• Follow the correct order ¬ to Ã. Otherwise, the hopper cover may be damaged.
• The hook à breaks easily.
5. Shake a bag of developer and pour it into the development hopper [A].
6. Reattach the hopper cover (hook x 3).
• Keep the developer off at both ends of the development unit enclosed in red lines in the diagram.
7. Turn the machine power on. The machine initializes the developer and resets the PM counter for the
developer. (For details of the developer initialization result, see "Developer Initialization Result" in the
"Troubleshooting" chapter.
8. Do the ACC procedure.
Toner Collection Bottle
If you will install a new bottle, and the old bottle is not in a full or near-full condition, then set SP 3902-017
to 1.
• If you do this, then the machine will reset the PM counter for the bottle automatically, after you turn
the power on again.
• If the bottle is in a full or near-full condition, it is not necessary to do this.
Image Creation
203
To Next Page
Loading...
Need help?
General
