Reboot/System Setting Reset
Software Reset
You can reboot the software with one of the following two procedures:
1. Turn the main power switch off and on.
2. Press and hold down together for over 10 seconds. When the machine beeps once, release
both buttons. After “Now loading. Please wait” shows for a few seconds, the copy window will open.
The machine is ready for normal operation.
System Settings and Copy Setting Reset
System Setting Reset
The system settings in the UP mode can be reset to their defaults. Use the following procedure.
1. Press User Tools/Counter .
2. Hold down and then press System Settings.
• You must press first.
3. Press yes when the message prompts you to confirm that you want to reset the system settings.
4. Press exit when the message tells you that the settings have been reset.
Copier Setting Reset
Use the following procedure to reset the copy settings in the UP mode to their defaults.
1. Press User Tools/Counter .
2. Hold down and then press Copier/Document Server Settings.
5. System Maintenance Reference
322
To Next Page
Loading...
Need help?
General
