• Over current or a defective element breaks the circuit.
3. Abnormal power supply
•The required voltage is not supplied to the devices.
4. Overheat/overcooling
• The environment is inappropriate for the board (the scanner unit).
5. Static electricity
• Static electricity of a high voltage occurs during the test.
6. Others
• The scanner and BICU are incorrectly connected.
When you have completed a check, turn the main switch off and on before you do another check. When
you have completed all necessary checks, turn the main switch off and on.
Scanner Test Mode
351
To Next Page
Loading...
Need help?
General
