022 Correction Environmental Correction: High *ENG
[-100 to 100 / 0 / 1 %]023 Initial Correction: Center *ENG
024 Initial Correction: Ends *ENG
025 Correction Interval Initial Correction *ENG [0 to 60 / 0 / 1 sec]
034 1bin: Plain: Center *ENG
[0 to 100 / 30 / 1 %]
035 1bin: Plain: Ends *ENG
[FF Limit Temp]
026 Offset: Center *ENG
[0 to 50 / 25 / 1 deg]
027 Offset: Ends *ENG
[FF Start Time]
028 F Gate Timer: FC: Full *ENG [0 to 10000 / 2100 / 1mm/sec]
029 F Gate Timer: FC: Half *ENG [0 to 10000 / 4000 / 1mm/sec]
030 F Gate Timer: BW: Full *ENG [0 to 10000 / 0 / 1mm/sec]
031 F Gate Timer: BW Half *ENG [0 to 10000 / 500 / 1mm/sec]
[FF Correction Time]
032 Error Correction: Full *ENG
[-5000 to 5000 / 0 / 1mm/sec]
033 Error Correction: Half *ENG
1120 [Continues Print Mode Switch]
001
Paper Feed Condition *ENG [0 or 2 / 0 / 1]
Selects the paper feed timing.
0: Productivity priority, 1: Fusing quality priory
1159 [Fusing Jam Detection]
001
SC Display *ENG [0 or 1 / 0 / 1]
Enables or disables the fusing consecutive jam (three times) SC detection.
0: No detection, 1: Detection
8. Appendix: SP Mode Tables
162
To Next Page
Loading...
Need help?
General
