• If you will not install the finisher at this time, install the holder bracket [G]. Otherwise, the customer
will damage the bridge unit if they pull up the bridge unit tray. When you install the finisher, you
will need this bracket during the installation procedure.
12. Turn on the main power switch of the machine.
13. Check the bridge unit operation.
14. Pull the extension tray [K] only if the 1000-sheet finisher (B408) or the 500-sheet finisher (D372) is
to be installed in the main machine.
Bridge Unit (D386)
77
To Next Page
Loading...
Need help?
General
