Instrument Function
R&S
®
SMBV100A
140Operating Manual 1407.6062.32 ─ 08
If a file is highlighted, it is overwritten when the file is stored.
SCPI command:
:MMEMory:CATalog on page 477
File Name
Enter the file name of the file without file extension. This file is then created.
SCPI command:
n.a.
Save
Stores the current instrument settings under the specified path.
SCPI command:
*SAV on page 436
:MMEMory:STORe:STATe on page 482
Fast Save
Determines whether the instrument performs an absolute or a differential storing of the
settings.
Enable this function to accelerate the saving process by saving only the settings with
values different to the default ones.
However, in some test setups, e.g while analyzing the generated WiMAX signal with R&S
FSQ, it is required to disable the fast save option.
Note: This function is not affected by the Preset function.
SCPI command:
[:SOURce<hw>]:BB:DM:SETTing:STORe:FAST on page 582
Refer to the descriptions of the firmware options for the correct syntx of the corresponding
SCPI command.
Save Immediate x
Stores the current instrument setting in one of the three intermediate memories.
These instrument settings are retained until a different instrument setting is stored in the
intermediate memory. When the instrument is switched off, the contents of the inter-
mediate memories are retained.
SCPI command:
*SAV on page 436
File Manager
Calls the "File Management" menu.
Directories can be created and files managed in this menu (see chapter 5.2.8.4, "File
Manager", on page 142).
SCPI command:
n.a.
General Instrument Settings
To Next Page
Loading...
