Rohde & Schwarz SMBV100A - Page 599

Remote Control Commands
R&S
®
SMBV100A
582Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:BB:DM:SETTing:LOAD <Filename>
This command loads the selected file with Custom Digital Modulation settings. The direc-
tory is set using command MMEM:CDIRectory. A path can also be specified, in which
case the files in the specified directory are read. The file extension may be omitted. Only
files with the file extension *.dm will be loaded.
Setting parameters:
<Filename> string
Example:
BB:DM:STAN:ULIS:LOAD 'DM_1'
loads file DM_1.
Usage: Setting only
[:SOURce<hw>]:BB:DM:SETTing:STORe <Filename>
This command stores the current Custom Digital Modulation settings into the selected
file. The directory is set using command MMEM:CDIRectory. A path can also be speci-
fied, in which case the files in the specified directory are read. Only the file name has to
be entered. User Standards are stored as files with the specific file extensions *.dm.
Setting parameters:
<Filename> string
Example:
BB:DM:STAN:ULIS:STOR 'DM_QAM'
stores the current Custom Digital Modulation settings into file
DM_QAM.
Usage: Setting only
[:SOURce<hw>]:BB:DM:SETTing:STORe:FAST <Fast>
Determines whether the instrument performs an absolute or a differential storing of the
settings.
Enable this function to accelerate the saving process by saving only the settings with
values different to the default ones.
Note: This function is not affected by the "Preset" function.
Parameters:
<Fast> 0 | 1 | OFF | ON
*RST: 1
[:SOURce<hw>]:BB:DM:STANdard:ULISt:CATalog?
This command reads out the files with Digital Standard settings in the default directory.
The default directory is set using command MMEM:CDIRectory. Only files with the file
extension *.dm_stu will be listed.
Return values:
<Catalog> string
SOURce Subsystem