Instrument Function
R&S
®
SMBV100A
214Operating Manual 1407.6062.32 ─ 08
Center Freq - Frequency Sweep
Sets the center frequency.
SCPI command:
[:SOURce<hw>]:FREQuency:CENTer on page 627
Span - Frequency Sweep
Sets the span.
SCPI command:
[:SOURce<hw>]:FREQuency:SPAN on page 631
Current Freq - Frequency Sweep
Displays the current frequency.
If "Step" is set, the frequency for the next frequency step of the sweep is entered here.
SCPI command:
[:SOURce<hw>]:FREQuency:MANual on page 629
Spacing - Frequency Sweep
Selects linear or logarithmic sweep spacing.
"Linear"
With the linear sweep, the step width is a fixed frequency value which
is added to the current frequency. The step width is entered below.
"Logarithmic"
With the logarithmic sweep, the step width is a constant fraction of the
current frequency. This fraction is added to the current frequency. The
logarithmic step width is entered below in %.
SCPI command:
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing on page 696
Shape - RF Frequency Sweep
Selects the cycle mode for a sweep sequence (shape).
"Sawtooth"
One sweep runs from start to stop frequency. Each subsequent sweep
starts at the start frequency, i.e. the shape of the sweep sequence
resembles a sawtooth.
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
