Instrument Function
R&S
®
SMBV100A
225Operating Manual 1407.6062.32 ─ 08
Start Freq - LF Sweep
Sets the start frequency.
SCPI command:
[:SOURce]:LFOutput:FREQuency:STARt on page 650
Stop Freq - LF Sweep
Sets the stop frequency.
SCPI command:
[:SOURce]:LFOutput:FREQuency:STOP on page 651
Current Freq - LF Sweep
Displays the current frequency.
If "Step" is set, the frequency for the next frequency step of the sweep is entered here.
SCPI command:
[:SOURce]:LFOutput:FREQuency:MANual on page 649
Spacing - LF Sweep
Selects linear or logarithmic sweep spacing.
SCPI command:
[:SOURce]:LFOutput:SWEep[:FREQuency]:SPACing on page 653
Shape - LF Frequency Sweep
Selects the cycle mode for a sweep sequence (shape)
"Sawtooth"
One sweep runs from start to stop frequency. Each subsequent sweep
starts at the start frequency, i.e. the shape of the sweep sequence
resembles a sawtooth.
"Triangle"
One sweep runs from start to stop frequency and back, i.e. the shape
of the sweep resembles a triangle. Each subsequent sweep starts at
the start frequency.
SCPI command:
[:SOURce]:LFOutput:SWEep[:FREQuency]:SHAPe on page 653
Step Lin/Log - LF Sweep
Sets the step width for the individual sweep steps. This entry is effective for all sweep
modes.
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
