Instrument Function
R&S
®
SMBV100A
343Operating Manual 1407.6062.32 ─ 08
The input is expressed as a number of symbols. If the setting "Fix marker delay to dynamic
range" is enabled, the setting range is restricted to the dynamic range. In this range the
delay of the marker signals can be set without restarting the marker and signal.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay on page 510
Current Range without Recalculation
Displays the dynamic range within which the delay of the marker signals can be set with-
out restarting the marker and signal.
The delay can be defined by moving the setting mark.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay:MINimum on page 511
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut<ch>:DELay:MAXimum on page 511
Fix marker delay to current range
Restricts the marker delay setting range to the dynamic range. In this range the delay
can be set without restarting the marker and signal.
SCPI command:
[:SOURce<hw>]:BB:ARB:TRIGger:OUTPut:DELay:FIXed on page 510
Clock Settings
The "Clock Settings" is used to set the clock source and a delay if required.
Sync. Mode
Selects the synchronization mode.
This parameter is used to enable generation of very precise synchronous signal of several
connected R&S SMBVs.
Note: If several instruments are connected, the connecting cables from the master
instrument to the slave one and between each two consecutive slave instruments must
have the same length and type.
Avoid unnecessary cable length and branching points.
"None"
The instrument is working in stand-alone mode.
"Sync. Master"
The instrument provides all connected instrument with its synchronisa-
tion (including the trigger signal) and reference clock signal.
"Sync. Slave"
The instrument receives the synchronisation and reference clock signal
from another instrument working in a master mode.
SCPI command:
[:SOURce<hw>]:BB:ARB:CLOCk:SYNChronization:MODE on page 507
Baseband Signal - Baseband Block
To Next Page
Loading...
