Remote Control Basics
R&S
®
SMBV100A
403Operating Manual 1407.6062.32 ─ 08
Configuring the controller
The instrument is preconfigured for networks using DHCP (dynamic host configuration
protocol). If this configuration is used, enter the computer name in the position of the IP
address.
To enable the external controller to communicate with the software via TCP/IP protocol,
set up a remote control link as follow:
1. Connect the controller and the instrument to the network (network cable) and switch
them on.
2. Start the 'Measurement & Automation Control' program on the controller.
3. Select "Devices and Interfaces > Create New".
4. Select "VISA TCP/IP Resource" and confirm with "Next".
5. Choose the type of TCP/IP resource you wish to add and select Next.
Starting a Remote Control Session
To Next Page
Loading...
