Remote Control Commands
R&S
®
SMBV100A
438Operating Manual 1407.6062.32 ─ 08
● Activating the preset state of all parameters that are not related to the signal path (
:DEVice:PRESet on page 438)
● Activating the original state of delivery (factory reset, :SYSTem:FPReset
on page 438). Only functions that are protected by a password remain unchanged
as well as the passwords themselves.
:DEVice:PRESet
The command presets all parameters which are not related to the signal path. This
includes presetting the LF generator and bit/block error measurement.
Example:
DEV:PRES
presets all instruments settings that are not related to the signal
path
Usage: Event
:SOURce<hw>:PRESet
The command presets all parameters which are related to the selected signal path.
Fading (if available) and transient recorder are only preset by command *RST.
Example:
SOUR:PRES
presets all settings that are related to signal path
SYSTem:PRESet
The command triggers an instrument reset. It has the same effect as:
●
the PRESET key on the front panel
●
the *RST command
For an overview of the settings affected by the preset function, see chapter 5.2.2, "Default
Instrument Settings - Preset Key", on page 104.
Example:
SYST:PRES
All instrument settings (also those that are not currently active) are
reset to their default values.
Usage: Setting only
:SYSTem:FPReset
The command triggers an instrument reset to the original state of delivery.
Note: Since Factory Preset resets the Remote Channel and network settings to the
default values, executing Factory Preset via remote control terminates the connection to
the instrument, if these settings had been configured to values different to the default
ones!
Preset Commands
To Next Page
Loading...
