Rohde & Schwarz SMBV100A - Page 550

Remote Control Commands
R&S
®
SMBV100A
533Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:BB:ARB:MCARrier:SETTing:CATalog?
This command queries the available settings files in the specified default directory. The
settings files are used to set the ARB multi carrier submenu. Only files with the file exten-
sion *.arb_multcarr will be listed.
Return values:
<Catalog> string
Example:
MMEM:CDIR '/var/smbv/user/waveform'
sets the default directory to /var/smbv/user/waveform.
BB:ARB:MCAR:SETT:CAT?
reads out all the settings files in the default directory.
Response: mcar1, mcar2
the directory contains the configuration files mcar1.arb_mult
carr and mcar2.arb_multcarr.
Usage: Query only
[:SOURce<hw>]:BB:ARB:MCARrier:SETTing:LOAD <Filename>
The command loads the settings file. If a settings file with the specified name does not
yet exist, it is created. The file extension may be omitted. Only files with the file extension
*.arb_multcarr will be loaded or created.
Setting parameters:
<Filename> string
Example:
BB:ARB:MCAR:SETT:LOAD
'/var/smbv/user/waveform/new'
creates settings file new.arb_multcarr.
Usage: Setting only
[:SOURce<hw>]:BB:ARB:MCARrier:SETTing:STORe <Filename>
The command stores the current settings of submenu "Multi Carrier" in a file in the speci-
fied directory. The file extension may be omitted, the files are stored with the file extension
*.arb_multcarr.
Setting parameters:
<Filename> string
Example:
BB:ARB:MCAR:SETT:STOR
'/var/smbv/user/waveform/mcarr2'
stores settings file mcarr2.arb_multcarr in the default direc-
tory.
Usage: Setting only
SOURce Subsystem