Remote Control Commands
R&S
®
SMBV100A
689Operating Manual 1407.6062.32 ─ 08
[:SOURce<hw>]:PULM:TRIGger:EXTernal:IMPedance <Impedance>
The command selects the impedance for external pulse trigger. The trigger is fed via the
PULSE EXT input.
Parameters:
<Impedance> G50 | G10K
*RST: G10K
Example:
SOUR:PULM:TRIG:EXT:IMP G50
selects 50 Ohm as the trigger impedance for the external pulse
trigger.
Usage: SCPI confirmed
Options: R&S SMBV-K22 (Pulse Modulator)
[:
SOURce<hw>]:PULM:TRIGger:EXTernal:SLOPe <Slope>
The command sets the polarity of the active slope of an applied trigger at the PULSE
EXT connector.
Parameters:
<Slope> POS | NEG
*RST: POSitive
Example:
PULM:TRIG:EXT:SLOP NEG
The pulse generator is triggered on the negative slope of the
external trigger signal.
Options: R&S SMBV-K23 (Pulse Generator)
[:SOURce<hw>]:PULM:TRIGger:MODE <Mode>
The command selects the trigger mode for pulse modulation.
Parameters:
<Mode> AUTO | EXTernal | EGATe
AUTO
The pulse modulation is generated continuously.
EXTernal
The pulse modulation is triggered by an external trigger event. The
trigger signal is supplied via the PULSE EXT connector.
EGATe
The pulse modulation is gated by an external gate signal. The sig-
nal is supplied via the PULSE EXT connector.
*RST: AUTO
Example:
PULM:TRIG:MODE EXT
selects triggering by an external trigger event.
Usage: SCPI confirmed
SOURce Subsystem
To Next Page
Loading...
