Remote Control Commands
R&S
®
SMBV100A
702Operating Manual 1407.6062.32 ─ 08
STATus:OPERation:PTRansition.....................................................................................703
STATus:PRESet............................................................................................................703
STATus:QUEStionable:CONDition...................................................................................704
STATus:QUEStionable:ENABle.......................................................................................704
STATus:QUEStionable[:EVENt].......................................................................................704
STATus:QUEStionable:NTRansition................................................................................704
STATus:QUEStionable:PTRansition.................................................................................705
STATus:QUEue[:NEXT]..................................................................................................705
STATus:OPERation:CONDition? <Condition >
The command queries the content of the CONDition part of the STATus:OPERation reg-
ister. This part contains information on the action currently being performed in the instru-
ment. The content is not deleted after being read out since it indicates the current hard-
ware status.
Parameters:
<Condition > string
Example:
STAT:OPER:COND
queries the Status:Operation:Condition register.
Usage: Query only
SCPI confirmed
STATus:OPERation:ENABle <Enable>
The command sets the bits of the ENABle part of the STATus:OPERation register. This
setting determines which events of the Status-Event part are forwarded to the sum bit in
the status byte. These events can be used for a service request.
Parameters:
<Enable> string
Example:
STAT:OPER:ENAB 32767
all events are forwarded to the sum bit of the status byte.
Usage: SCPI confirmed
STATus:OPERation[:EVENt]? <EVENt>
The command queries the content of the EVENt part of the STATus:OPERation register.
This part contains information on the actions performed in the instrument since the last
readout. The content of the EVENt part is deleted after being read out.
Parameters:
<EVENt> string
Example:
STAT:OPER:EVEN
queries the STATus:OPERation:EVENt register.
Usage: Query only
SCPI confirmed
STATus Subsystem
To Next Page
Loading...
