Rohde & Schwarz SMBV100A - Page 737

Remote Control Commands
R&S
®
SMBV100A
720Operating Manual 1407.6062.32 ─ 08
R&S name SCPI name Command under manual control
EXTernal EXTernal "Ext Single" and "Ext Step" mode.
Use command LFO:SWEep:MODE
to select between the two sweep
modes.
EAUTo - "Ext Start/Stop" mode.
TRIGger0[:SWEep]:SOURce...........................................................................................720
:TRIGger<hw>:LFFSweep:SOURce.................................................................................720
:TRIGger<hw>:FSWeep[:IMMediate]................................................................................721
:TRIGger<hw>:FSWeep:SOURce....................................................................................721
:TRIGger<hw>:PSWeep[:IMMediate]................................................................................722
:TRIGger<hw>:PSWeep:SOURce....................................................................................723
:TRIGger<hw>[:SWEep][:IMMediate]................................................................................723
:TRIGger<hw>[:SWEep]:SOURce....................................................................................724
TRIGger0[:SWEep]:SOURce <Source>
:TRIGger<hw>:LFFSweep:SOURce <Source>
The command sets the trigger source for the LF sweep. The trigger is triggered by the
command :SOURce:LFOutput:SWEep[:FREQuency]EXECute.
The names of the parameters correspond directly to the various settings under manual
control. SCPI uses other names for the parameters; these names are also accepted by
the instrument. The SCPI names should be used if compatibility is an important consid-
eration.
An overview of the various names is given in the table 7-3.
TRIGger Subsystem