Schweitzer Engineering SEL-2032 - Page 189

1
Date Code 20120126 Instruction Manual SEL-2032 Communications Processor
Settings Sheets
Worksheet SET G
Date: ________________________________
Approved by: _________________________
SEL-2032 S/N: _______________________
Worksheet SET G
Device Identification = _______________________________________________________________________
SEL-2032 Time Synchronization Source (IRIG, DNP, OFF) = ________________________________________
Type of IRIG Source (Modulated/Demodulated) =__________________________________________________
PCFail = __________________________________________________________________________________
Enable use of intermediate logic (Y/N) = _________________________________________________________
V = _______________________________________________________________________________________
W = ______________________________________________________________________________________
X = ______________________________________________________________________________________
Y = ______________________________________________________________________________________
Z = _______________________________________________________________________________________
V Timer Pickup time (seconds) = _______________________________________________________________
V Timer Dropout time (seconds) = ______________________________________________________________
W Timer Pickup time (seconds) = ______________________________________________________________
W Timer Dropout time (seconds) = _____________________________________________________________
X Timer Pickup time (seconds) = _______________________________________________________________
X Timer Dropout time (seconds) = ______________________________________________________________
Y Timer Pickup time (seconds) = _______________________________________________________________
Y Timer Dropout time (seconds) = ______________________________________________________________
Z Timer Pickup time (seconds) = _______________________________________________________________
Z Timer Dropout time (seconds) = ______________________________________________________________
ALARM = _________________________________________________________________________________
OUT1 = ___________________________________________________________________________________
OUT2 = ___________________________________________________________________________________
OUT3 = ___________________________________________________________________________________
OUT4 = ___________________________________________________________________________________
Courtesy of NationalSwitchgear.com