Section 06 STEERING AND PROPULSION
Subsection 01 (STEERING)
11.2 Tighten the half-rings retaining screws to
specification.
TIGHTENING TORQUE
Half-rings retaining
screws
8N•m ± 1N•m
(71 lbf•in ±9lbf•in)
12. Install the b
all joint on the end of the steering
cable.
12.1 The threaded portion of steering cable
inserted into ball joint should be within
9 mm ± 1 mm (.354 in ± .039 in).
A
smr2006-031-006_a
A. 9 mm ± 1 mm (.354 in ± .039 in)
12.2 Tighten jam nut to specification.
12.3 Position the steering cable ball joint to the
nozzle as per following illustration.
219
100893-028-023_a
1. Ball joint bolt
2. Ball joint
3. Was
her
TIGHTENING TORQUE
Ball joint jam nut
2.5 N•m ± 0.3 N•m
(22 lbf•in ±3lbf•in)
Ball joint bolt
7N•m ± 1N•m
(62 lbf•in ±9lbf•in)
The installation of the steering cable to the steer-
ing column is the reverse of the removal proce-
dure. However, pay attention to the following.
TIGHTENING TORQUE
Cable support retaining
screw
5.5 N•m ± 0.5 N•m
(49 lbf•in ±4lbf•in)
Carry out
ADJ
USTING THE ALIGNMENT OF THE
STEERING
.Se
e procedure in this subsection.
The threaded portion of steering cable inserted
into the end fitting should be 9 mm ± 1 mm
(.354 in ± .039 in).
219100893-028-308_a
A. 9mm ± 1mm (
.354 in ± .039 in)
Install a ll removed parts using appropriate proce-
dure.
Adjusting the Steering Cable
1. Steering cable adjustment is required only if:
– A steering cable end ball joint has been re-
placed or loosened/tightened.
– Steerin
g cable adjustment nut has been loos-
ened/ti
ghtened.
– Steering cable has been replaced.
– Steering column or support has been re-
placed.
2. Lock the jet pump nozzle position b y installing
a 10 mm (3/8 in) rod through the trimming ring
as the following illustration.
160 219100963-017
To Next Page
Loading...
