Service Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
12-36 HiPath 3000/5000 V9, Service documentation
service.fm
Service and Maintenance Tasks
● The IP workpoint clients in the Small Remote Sites (branches) should use the same call
numbers in normal mode (registered with HiPath 4000) and in emergency mode (regis-
tered with HiPath 3000).
In this case, the call numbers are assigned via HiPath User Management.
When configuring the IP workpoint clients (system clients) via HiPath 3000/5000 Manager
E their call numbers should be deleted. Otherwise it is not possible to assign call numbers
via HiPath User Management without taking further steps.
● The IP workpoint clients in the Small Remote Sites (branches) should use different call
numbers in normal mode (registered with HiPath 4000) and in emergency mode (regis-
tered with HiPath 3000).
In this case, the call numbers are assigned via HiPath 3000/5000 Manager E when config-
uring the IP workpoint clients (system clients).
An IP workpoint client configured in this way can then be assigned a HiPath 4000 call num-
ber for normal mode via HiPath User Management.
The following configuration data for an IP workpoint client is modified via HiPath User Manage-
ment:
● Internal call number
● DID number
● Directory name
● CFSS destination
● Access groups
>
Refer to the HiPath User Management service and administrator documentation for
information on the installation and configuration procedures for HiPath 3000/5000
and HiPath 3000 Element Manager.
To Next Page
Loading...
