Siemens HiPath 3000 Series - B Codes for ActivatingDeactivating Features

fcodes.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
B-1
Codes for Activating/Deactivating Features
B Codes for Activating/Deactivating Features
This appendix describes the options for activating and deactivating features depending on the
different workpoint clients (WpC).
Table B-1 contains all the activation/deactivation procedures for analog workpoint clients,
TDM workpoint clients without a display and CMI mobile phones. The table only
contains the access codes for TDM workpoint clients with a display, CMI feature
mobile phones and IP workpoint clients. The procedures for S
0
workpoint clients
either correspond to procedures for analog workpoint clients or are handled via
the relevant ISDN protocol with the terminal-specific user interface.
The table also contains information about the effect of the telephone lock and
the status-specific locking of features.
Table B-2 contains a description of the various types of workpoint clients.
Table B-1 Codes for Activating/Deactivating Features
Feature
Operating procedure for
Supported
workpoint cli-
ents
(see abbrevi-
ations in
Table B-2)
Locking of
feature
Note
TDM work-
point clients
without dis-
play,
CMI mobile
phones,
analog work-
point clients
1
S
0
work-
point cli-
ents
TDM workpoint clients with
display,
CMI feature mobile phones,
IP workpoint clients
OpenScape
Personal Edition
Code +
Procedure
Code Code
Key Menu
Code
via
Telephone lock
Status
locking on
Fixed
Programm-
able
Dialog
Service
Activate relay *90+Relay no. 7590... *90... – V, T – H – AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Deactivate re-
lay
#90+Relay no. 7690... #90... – V, T – H – AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Accept call
waiting
*55 7555 *55 – V BR,
WA,
RG,
GS,
BS
U Mouse
click,
Drag&
Drop
AN, DIG, ENT,
S0, CMI, IP-
SC, IPH3
– – Also possible via the
DSS, GESP, LTG or
MUSAP key
Bar call wait-
ing (automatic)
#490 76490 #490 – V, T RH U1 Fea-
ture
key
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Abbreviations:
● Call states: RH = idle, BR = ready, WA = digit input, BS = busy, RK = incoming call, RG = outgoing call, GS = call
● Key programming: V = key can be programmed with complete feature, U = key can be programmed to start procedure, T = key with
toggle functionality
● Menu level: H = Main menu, U1 = 1st submenu, U2 = 2nd submenu