Siemens HiPath 3000 Series - Page 1206

Codes for Activating/Deactivating Features Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
B-2 HiPath 3000/5000 V9, Service documentation
fcodes.fm
Allow call wait-
ing (automatic)
*490 75490 *490 – V, T RH U1 Fea-
ture
key
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Silent call wait-
ing (camp-on)
on
– – *87 – V, T RH U1 Local
feature
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Silent call wait-
ing (camp-on)
off
– – #87 – V, T RH U1 Local
feature
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Logon mode
(for handset)
*942+Code
+Stn. no.
– *942 – – – H – DIG, CMI X
Query caller
list
– – #82... – V RH,
BR
U Local
feature
menu
DIG, IPSC,
IPSI
X Only if enabled
Missed calls -
save number/
save call num-
ber
– – *82 – – RG,
GS
– Local
active
menu
DIG, IPSC X RK,
BR,
WA
Only if enabled
Do not disturb
on
*97 7597 *97 – V, T RH U Fea-
ture
key
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Do not disturb
off
#97 7697 #97 – V, T RH U Fea-
ture
key
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Call forward-
ing on, internal
or external
*1+Type+Stn.
no.
751...
or
Call for-
warding
(local S
0
WpC
function-
ality)
*1... – V, U,
T
RH U Fea-
ture
key
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Later selection of
the forwarding type:
1 = All calls, 2 = Ex.
calls only, 3 = Int.
calls only
Table B-1 Codes for Activating/Deactivating Features
Feature
Operating procedure for
Supported
workpoint cli-
ents
(see abbrevi-
ations in
Table B-2)
Locking of
feature
Note
TDM work-
point clients
without dis-
play,
CMI mobile
phones,
analog work-
point clients
1
S
0
work-
point cli-
ents
TDM workpoint clients with
display,
CMI feature mobile phones,
IP workpoint clients
OpenScape
Personal Edition
Code +
Procedure
Code Code
Key Menu
Code
via
Telephone lock
Status
locking on
Fixed
Programm-
able
Dialog
Service
Abbreviations:
● Call states: RH = idle, BR = ready, WA = digit input, BS = busy, RK = incoming call, RG = outgoing call, GS = call
● Key programming: V = key can be programmed with complete feature, U = key can be programmed to start procedure, T = key with
toggle functionality
● Menu level: H = Main menu, U1 = 1st submenu, U2 = 2nd submenu