fcodes.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
B-3
Codes for Activating/Deactivating Features
Call forward-
ing off
#1 761 #1 – V, T RH U1 Fea-
ture
key
AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Call forward-
ing in EDSS1
trunk on (not
for tenant ser-
vice)
– – *64... – V, U,
T
RH U1 – AN, DIG, ENT,
S0, CMI, IPSC
X RK,
BS
Only for S
0
trunk
connection and au-
thorized stations.
Later selection of
the forwarding type:
1 = immediate, 2 =
unanswered calls, 3
= on busy.
All call forwarding
types can be acti-
vated independently
of each other.
Call forward-
ing in EDSS1
trunk off (not
for tenant ser-
vice)
– – #64... – V, T RH U1 – AN, DIG, ENT,
S0, CMI, IPSC
X
CFSS (Call
forwarding sta-
tion out of ser-
vice)
– – *9411 – V, U,
T
– U1 – IPSC X RK,
BS
CFSS (call forward-
ing station out of
service) has higher
priority than normal
call forwarding.
CFSS (Call
forwarding sta-
tion out of ser-
vice)
– – #9411 – V, T – U1 – IPSC X
Call forward-
ing on for each
MULAP
*501+MU-
LAP+Type+Stn.
no.
75501 *501 – V, T – H – AN, DIG, ENT,
S0, CMI, IPSC
Only for MULAP
members
Call forward-
ing off for each
MULAP
#501+MULAP 76501 #501 V, T – H – AN, DIG, ENT,
S0, CMI, IPSC
Only for MULAP
members
UCD (uniform
call distribu-
tion), logon
*401+ID – *401.. – V, U,
T
– U2 Fea-
ture
key
AN, DIG, ENT,
CMI, IPSC
X RK,
BS
Only for UCD group
members
Table B-1 Codes for Activating/Deactivating Features
Feature
Operating procedure for
Supported
workpoint cli-
ents
(see abbrevi-
ations in
Table B-2)
Locking of
feature
Note
TDM work-
point clients
without dis-
play,
CMI mobile
phones,
analog work-
point clients
1
S
0
work-
point cli-
ents
TDM workpoint clients with
display,
CMI feature mobile phones,
IP workpoint clients
OpenScape
Personal Edition
Code +
Procedure
Code
Code
Key Menu
Code
via
Telephone lock
Status
locking on
Fixed
Programm-
able
Dialog
Service
Abbreviations:
● Call states: RH = idle, BR = ready, WA = digit input, BS = busy, RK = incoming call, RG = outgoing call, GS = call
● Key programming: V = key can be programmed with complete feature, U = key can be programmed to start procedure, T = key with
toggle functionality
● Menu level: H = Main menu, U1 = 1st submenu, U2 = 2nd submenu
To Next Page
Loading...
