Notes for Editing the File snmpd.cnf Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
E-2 HiPath 3000/5000 V9, Service documentation
snmpd.fm
Trap Destination
● snmpNotifyTag
Designation that must correspond with the snmpTargetAddrTagList (snmpTagetAd-
drEntry), so that a trap can be sent.
The value is always “hipath”.
● snmpNotifyType
Type of traps that are to be sent (trap, about).
For HiPath 5000 always “trap”.
● snmpNotifyStorageType
Always “nonVolatile” (persistent storage necessary).
snmpTargetAddrEntry <snmpTargetAddrName> <snmpTargetAddrTDomain> <sn-
mpTargetAddrTAddress> <snmpTargetAddrTimeout> <snmpTargetAddrRetry-
Count> <snmpTargetAddrTagList> <snmpTargetAddrParams> <snmpTargetAd-
drStorageType> <snmpTargetAddrTMask> <snmpTargetAddrMMS>
● snmpTargetAddrName
Any unambiguous identifier for the entry.
String with 1-32 characters.
● snmpTargetAddrTDomain
Transport type for the entry.
String: snmpUDPDomain or snmpIPXDomain.
● snmpTargetAddrTAddress
Destination address for traps.
The format depends on the entry snmpTargetAddrTDomain.
For snmpUDPDomain: IP address + port (for example 192.132.123.98:162), whereby 0
may also be entered as a port. In this case the default port will be used.
● snmpTargetAddrTimeout
Timeout: Default is 1500. For HiPath 5000, 100 is used.
● snmpTargetAddrRetryCount
Retry count: Default is 3.
● snmpTargetAddrTagList
Designation that must correspond with a snmpNotifyTag (snmpNotifyEntry) so that
a trap can be sent to the given address.
The value is always “hipath”.
● snmpTargetAddrParams
Designation that refers to an entry in a snmpTargetParamsEntry (snmpTarget-
ParamsName).
The value is always “v1Params”.
● snmpTargetAddrStorageType
Always “nonVolatile” (persistent storage necessary).
To Next Page
Loading...
