Boards for HiPath 3000 Nur für den internen Gebrauch
A31003-H3590-S100-7-7620, 06/2012
3-362 HiPath 3000/5000 V9, Service documentation
boards.fm
Options
ANI4 module contact assignments
Red LED - Checksum Status
On The received caller ID signal has a checksum error.
The LED is reset after the next correct caller ID mes-
sage is received.
If the red LED is on after ev-
ery call: the FSK signal is
provided, but is not Bellcore-
compliant on the customer
side. This must be corrected
by the service provider.
Off Checksum is OK. –
Table 3-177 ANI4 (for selected countries only) - Contact Assignments
Contact Connector X3
Component Side
Connector X3
Solder Side
Connector X4
1 -- Not assigned a-wire (tip), trunk 1
2 b-wire (ring), trunk 1 -- b-wire (ring), trunk 1
3 -- a-wire (tip), trunk 1 a-wire (tip), trunk 2
4 b-wire (ring), trunk 2 -- b-wire (ring), trunk 2
5 -- a-wire (tip), trunk 2 a-wire (tip), trunk 3
6 b-wire (ring), trunk 3 -- b-wire (ring), trunk 3
7 -- a-wire (tip), trunk 3 a-wire (tip), trunk 4
8 b-wire (ring), trunk 4 -- b-wire (ring), trunk 4
9 -- a-wire (tip), trunk 4 –
10 GMZ -- –
GMZ= Call charging module assignment
Table 3-176 ANI4 (for selected countries only) - LED Statuses for Trunk 1
LED Meaning Action
To Next Page
Loading...
