Siemens HiPath 3000 Series - Page 733

start_h5.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
6-51
Nur für den internen Gebrauch Startup and Administration HiPath 5000
Perform HiPath 5000 Basic Configuration
● Load from system (to load a CDB directly from a node)
In this case, select the HiPath 3000 node with the CDB that is to be loaded from the
subsequent Transfer (Communication Settings) dialog that appears. You must then
start the transfer (system -> PC).
If the Copy netwide data in node option is activated, the service and substitution codes
are copied from the CDB firstly created to all other CDB files of the node belonging to IP
networking.
4. Clicking Finish opens the Transfer... dialog. Here, specify the node whose data should be
read.
5. To add the node, invoke File - HiPath 5000 RSM/AllServe - Transfer - HiPath 5000 RSM/
AllServe Server.
6. The Transfer (HiPath 5000 RSM/AllServe Server) dialog appears.
Apply the node data to the server net file by clicking the Add node button.
The number of nodes loaded during previous actions is displayed.
7. Finally, rewrite the data from HiPath 3000/5000 Manager E to the HiPath 5000 server
(Manager –> Server button).