Basic functions
7.30 Web server
Drive functions
456 Function Manual, 11/2017, 6SL3097-4AB00-0BP5
Displaying and changing drive parameters
The parameter values are displayed via the tab in the "Parameter" display area. Each list
created is displayed as a separate tab.
The parameter display is updated regularly. If an update is not possible, the corresponding
parameters are marked red.
To change the parameter values of a parameter list, then you require the corresponding
write rights (see Chapter "Access rights for parameter lists (Page 439)"). In addition, the
write and know-how protection apply.
Note
You can find detailed information about the following parameters in the SINAMICS
S120/S150 List Manual in Section "Parameters for write protection
and know-how
Parameters that can be changed with active know-how protection,
see Section "Parameters with KHP_WRITE_NO_LOCK"
Parameters that can only be read with active know-how protection,
see Section "Parameters with KHP_ACTIVE_READ"
Generally, only those parameter values in the parameter list can be changed for which you
can see a “Change" button to the right of the line.
● The required parameter list is created in the Web server.
To Next Page
Loading...
Need help?
General