Basic functions
7.30 Web server
Drive functions
440 Function Manual, 11/2017, 6SL3097-4AB00-0BP5
Changing access rights to parameter lists in the Web server
1. Start the Web server (see Starting the Web server (Page 440)).
2. Click the "Parameter" entry in the navigation.
The parameter display is then active on the right in the browser. The "Define" tab is
displayed.
3. Click the “Define" tab.
All parameter lists are displayed in the “List name" drop-down list.
4. Select the required individual parameter list.
5. Click “Access".
The "Access rights" dialog box opens with the access settings of the parameter list.
Figure 7-29 Access rights
The preset access rights can be seen for the "SINAMICS" and the "Administrator" users.
The checkbox is selected for the activated access rights.
6. Activate or deactivate the relevant access rights by clicking the corresponding checkbox.
7. Click “Confirm" to confirm the settings.
The dialog box closes.
Starting the Web server
Requirements
● The Web server is active in the configuration of STARTER (see Basic configuration
(Page 431)).
● Functional communication settings
● PG/PC is connected to the Control Unit (target device)
To Next Page
Loading...
Need help?
General