Basic functions
7.30 Web server
Drive functions
Function Manual, 11/2017, 6SL3097-4AB00-0BP5
451
Displaying and changing drive parameters
7.30.9.1
Creating a parameter list
Access to all drive parameters is possible with the Web server user-defined parameter lists:
● including DCC and Tec parameters
● including Level 4 parameters if the corresponding password has been set
Up to 20 parameter lists, each with up to 40 parameters, can be managed in the Web server.
The created parameter lists are saved on the memory card of the drive. Therefore, a
parameter selection performed once is retained for further access even after the drive is
switched off.
An existing write and know-how protection also applies without restrictions for parameter
access via the Web server.
Note
You can find detailed information about the following parameters in the SINAMICS
S120/S150 List Manual in Section "Parameters for write protection and know
-how
Parameters that can be changed with active know-how protection,
see Section "Parameters with KHP_WRITE_NO_LOCK"
Parameters that can only be read with active know-how protection,
see Section "Parameters with KHP_ACTIVE_READ"
To Next Page
Loading...
Need help?
General