Sirona Intego - Flushing the Cuspidor; Operating Light; Fn Key

64 57 498 D3543
140 D3543.201.01.05.02 08.2016
4Operation Sirona Dental Systems GmbH
4.6Assistant element Operating Instructions INTEGO
4.6.3.3
Flushing the cuspidor
The flushing function can be used for rough cleaning of the cuspidor
during treatment.
➢ Press the
Flushing fixed key.
 The flushing function is activated for the preset flushing time.
4.6.3.4
Operating light
Repeatedly press the Operating light fixed key to set the following
switching positions at the assistant element:
1. Switched on: The operating light is switched on at the preset
brightness level.
2. Composite function: This function is used to prevent premature
curing of composite materials.
3. Switched off
➢ Press the
Operating light fixed key, repeat if necessary.
 The operating light switches to “on,” “composite function” or “off”.
4.6.3.5
Fn key
The Fn key starts and stops the timer. It is preset in the Setup of the
treatment center, see "Presetting the timer" [ → 193].
✔ The time or speed/intensity is shown on the EasyPad display.
➢ Press the
Fn key .
 The timer is started immediately. The preset time counts down on
the EasyPad display of the dentist element.
 When the time is up, a short acoustic signal sounds.
Press again to stop the timer and reset the countdown. The timer can then
be restarted.
Fn