Sirona Intego - Tumbler Filling with Automatic Sensor Control

64 57 498 D3543
150 D3543.201.01.05.02 08.2016
4Operation Sirona Dental Systems GmbH
4.7Water unit Operating Instructions INTEGO
4.7.2.3
Tumbler filling with automatic sensor control
Available only for the Comfort water unit and not in all countries
The automatic sensor control is an option on the Comfort water unit and
is not available in all countries.
With this tumbler filler, the automatic sensor control detects the filling
level of the tumbler automatically.
If the tumbler is removed before the preset filling level has been reached,
the water flow stops immediately.
Filling the tumbler
✔ The tumbler must not be transparent.
✔ The tumbler must always be placed in the center of the area provided
for it.
➢ Place the tumbler under the tumbler filler.
 The tumbler is filled automatically.
 After the preset filling level has been reached, the water flow stops
automatically.
Cross-reference to DARWIN
If required, the tumbler can be refilled manually by the Tumbler filling key,
see "Tumbler filling on the EasyPad" [ → 148] or"Tumbler filling on the
EasyTouch" [ → 149].
Automatic sensor control after switch-on
Setting the filling level
The tumbler filling level can be preset.
1. Open the maintenance flap A on the base of the water unit.
2. Set the filling level with control knob B.
IMPORTANT
Tumbler filling after switch-on
If an empty tumbler is standing below the tumbler filler when the
treatment center is switched on, the tumbler will not be filled
automatically. To activate automatic tumbler filling, remove the tumbler
briefly and then put it back again.