Sirona Intego - Cleaning the Outlet Lines of the Cuspidor

64 57 498 D3543
250 D3543.201.01.05.02 08.2016
5Care, cleaning and maintenance by the practice team Sirona Dental Systems GmbH
5.5Components of the water unit Operating Instructions INTEGO
1. Remove the gold trapC.
2. Hold the cuspidor bowl firmly with both hands. Loosen the bayonet
catch by twisting the cuspidor bowl counterclockwise.
A rubber gasket is attached to the bayonet catch of the water unit to seal
its closure. Lubricate this gasket before reinserting the cuspidor bowl. For
lubricants, see "Care, cleaning and disinfecting agents." [ → 250]
Make sure that the bayonet catch snaps into place when you reinsert it.
After snapping into place, the higher side of the cuspidor bowl must be
located below the tumbler outlet.
5.5.3 Cleaning the outlet lines of the cuspidor
With the option chemical suction hose cleaning, the drain outlets of the
cuspidor are not cleaned/disinfected. If the treatment center is equipped
with this option, the drains of the cuspidor must therefore be cleaned
weekly. Use the same agent as for the suction lines.
Care, cleaning, and disinfecting agents
Vacuum system, foaming cleaning agents
1. Prepare 1 liter of cleaning solution in a separate container according
to the manufacturer's instructions and mix it thoroughly.
C
C
NOTICE
Approved care, cleaning, and disinfecting agents
Use only care, cleaning and disinfecting agents approved by Sirona, see
"Care, cleaning, and disinfecting agents" [ → 205].
NOTICE
Domestic cleaning agents foam up.
Foaming cleaning agents often cause foam and water to be sucked into
the dry suction system. This can cause damage to the suction machine.
➢ Use only care, cleaning and disinfecting agents approved by Sirona,
see"Care, cleaning, and disinfecting agents" [ → 205].