Sirona Intego - Page 173

64 57 498 D3543
D3543.201.01.05.02 08.2016
173
Sirona Dental Systems GmbH 4Operation
Operating Instructions INTEGO 4.10Operating light
båÖäáëÜ
Setting LEDview
PLUS
on the EasyTouch
1. Press and hold the Operating Light fixed key on the dentist element
(> 2 s).
 The settings screen of the operating light is displayed on the
touchscreen.
2. Use the – and + keys to set the desired brightness of the operating
light (7 levels). The – key decreases the brightness and the + key
increases it.
3. Use the – and + keys to set the desired light temperature of the
operating light (3 levels). The – key decreases the light temperature
and the + key increases it.
4. Touch the
Sensor control key.
 If the key is highlighted in orange, the operating light can be
controlled with the contactless sensor. The keys for adjusting the
operating distance are displayed.
5. Use the – and + keys to set the desired operating distance (5 levels).
The – key decreases the operating distance and the + key increases
it. You can try out the setting directly on the operating light without
leaving the setting program. The setting should be selected so that
the contactless sensor cannot be operated unintentionally.
6. Touch the Sensor control key again to switch off the sensor control.
 The key is no longer highlighted in orange and the keys for
adjusting the operating distance are faded out.