Ski-Doo REV Series Shop Manual

Section04ENGINE
Subsection 03 (MAGNETO SYSTEM)
Magneto Flywheel
Clean crankshaft extension (taper) and apply Loc-
tite 243 (blue) on taper, then position Woodruff
key, magneto flywheel no. 3 and lock washer on
crankshaft.
Clean magneto flywheel nut threads and apply
Loctite 243 (blue) then tighten nut no. 1 to 125
N•m(92lbf•ft) for liquid cooled engines.
At reassembly coat all electric connections except
Deutsch housings (waterproof housing) with sili-
cone dielectric grease (P/N 293 550 004) to pre-
vent corrosion or moisture penetration.
CAUTION: Do not use silicone «sealant»,this
product will corrode contacts. Do not apply sil-
icone dielectric grease on any Deutsch water-
proof housing otherwise housing seal will be
damaged.
Ignition Timing
Check as described in IGNITION TIMING.
mmr2004-Rev 125

Ski-Doo REV Series Specifications

General

Chassis	REV
Track Width	15 in
Fuel Capacity	10.6 gal
Seating Capacity	1
Reverse	Available on most models
Electric Start	Available on most models