Ski-Doo REV Series Shop Manual

Section04ENGINE
Subsection 01 (593, 593 HO, 593 HO SDI AND 793 HO ENGINE TYPES)
A32C0FA
SEAMING COMPLETED — CONTACT SURFACES COVERED
AND SCREW HOLES SURROUNDED
Screw all crankcase bolts in place in the following
sequence and to the appropriate torque; this must
be done in two steps torquing: first, screw bolts
up to 60% of the final torque (18 N•m(13.5lbf•ft)
for most of the bolts), then, tighten to the required
torque (i.e. 29 N•m(21lbf•ft)).
11
A32C3FA
BA
9 14 4 1 16 5
8
18
12
10 13
2
3
15 6 7 17
19
B
20
B
21
B B
A. Torque bolts 1 through 16 to 29 N•m(21lbf•ft)
B. Torque bolts 17 through 21 to 9 N•m(80lbf•
in)
593 HO, 593 SDI and 793 HO Engine Types
Install oil seal cover.
BREAK-IN
After rebuilding an engine, always observe a
break-in period as described in Operator’s Guide.
mmr2004-Rev 109

Ski-Doo REV Series Specifications

General

Chassis	REV
Track Width	15 in
Fuel Capacity	10.6 gal
Seating Capacity	1
Reverse	Available on most models
Electric Start	Available on most models