Section 07 ELECTRICAL SYSTEM
Subsection 03 (BATTERY)
Connect RED positive cable it to positive battery
terminal. Connect RED wire (coming from 30 A
fuse).
Connect BLACK negative cable LAST.
WARNING
Battery BLACK negative cable must always be
disconnected first and connected last.
WARNING
Never charge or boost battery while installed
on vehicle.
Cover the RED positive terminal with rubber boot.
Apply silicone dielectric grease (P/N 293 550 004)
on battery posts and connectors.
CABLE TERMINAL INSTALLATION
Carefully strip the wire approximately to 10 mm
(1/2 in) in length, using a wire stripping tool or
sharp blade/knife.
A32E2QA
A
A. 10 mm (1/2 in)
NOTE: Make sure not to cut wire strands while
stripping the wire.
Install the appropriate terminal on the wire accord-
ing to the requirement. Refer to appropriate parts
catalog.
A32E2RA
INSTALLATION OF TERMINAL
Follow the instructions provided with the crimp pli-
ers (P/N 529 035 730) to select the proper position
of the tool.
NOTE: Different wires require different crimp pli-
ers settings, so make sure to follow the instruction
supplied with the tool.
2
A32E2SA
1
POSITIONING THE CRIMP PLIERS
1. Press
2. Rotate
After positioning the crimp pliers, crimp the termi-
nal already installed on wire.
A32E2TA
CRIMPING OF WIRE
mmr2004-Rev 261
To Next Page
Loading...
Need help?
General
