Ski-Doo REV Series Shop Manual

Section 07 ELECTRICAL SYSTEM
Subsection 01 (IGNITION TIMING)
Start the engine and point timing light on timing
mark. Bring engine to 3500 RPM for a brief in-
stant.
A29E0UA
The timing mark must be aligned with pointer end.
If such is not the case, note if timing is retarded or
advanced.
ENGINE TYPE TOLERANCE
593 ±1°
593 HO, 593 HO SDI,
793 HO
±0.5°
A29E0VA
TIMING RETARDED BY ABOUT 1°
A29E0WA
TIMING ADVANCED BY ABOUT 2°
CHANGING TIMING
All Engine Types
NOTE: To change the timing on the SDI engines,
the VCK is mandatory. The MPEM programmer
cannot be used with these engines.
VCK (Vehicle Communication Kit)
VCK (Vehicle Communication Kit) (P/N 529 035
981) can be used, with B.U.D.S. software to
change the ignition timing. Look under the
proper Setting section of the B.U.D.S. software
to change the ignition timing.
A32A1TA
Detailed information about the B.U.D.S. software
and its usage is available under its Help section.
mmr2004-Rev 253

Ski-Doo REV Series Specifications

General

Chassis	REV
Track Width	15 in
Fuel Capacity	10.6 gal
Seating Capacity	1
Reverse	Available on most models
Electric Start	Available on most models