EasyManuals Logo

Ski-Doo REV Series Shop Manual

Ski-Doo REV Series
436 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #418 background imageLoading...
Page #418 background image
Section 11 TECHNICAL DATA
Subsection 04 (TECHNICAL DATA LEGENDS)
TECHNICAL DATA LEGENDS
ENGINE LEGEND
ABDC: After Bottom Dead Center
ATDC: After Top Dead Center
BBDC: Before Bottom Dead Center
BTDC: Before Top Dead Center
CDI: Capacitor Discharge Ignition
IACV: Idle Air Control Valve
K: Kilo (x 1000)
MAG:
Magneto
N.A.: Not Applicable
PTO: Power Take Off
SDI: Semi-Direct Injection
W: Watt
(1) The maximum horsepower RPM applicable
on the vehicle. It may be different under
certain circumstances and BOMBARDIER
reserves the right to modify it without obli-
gation.
(2)
Crankshaft end-play is not adjustable on
these models. Specification is given for
verification purposes only.
(3) At 3500 RPM with headlamp turned on.
(4) All resistance measurements must be per-
formed with parts at room temperature (ap-
prox. 20°C(68°F)). Temperature greatly af-
fects resistance measurements.
(5) Press fit type, not replaceable.
(6) Needle with one groove, not adjustable.
(7) Drive pulley retaining screw: torque to 80
to 100 N•m(59to74lbf•ft), install drive
belt, accelerate the vehicle at low speed
(maximum 30 km/h (20 MPH)) and apply the
brake; repeat 5 times. Retorque screw to
90 to 100 N•m (66 to 74 lbf•ft).
(8)
CAUTION: Do not attempt to adjust gap
on spark plug BR 9 ECS. The specification
is given for verification purpose only. If
found out of specification, replace with a
new one.
(9) The engine speed for transmission calibra-
tion applicable on the vehicle. It may be
different under certain circumstances and
BOMBARDIER reserves the right to modify
it without obligation.
(10) Use Bombardier premixed coolant (P/N 293
600 038) or a solution of ethylene glycol an-
tifreeze for aluminum engines with distilled
water (50% antifreeze, 50% distilled water).
(11) Drive pulley retaining screw: torque to 125
to 135 N•m (92 to 100 lbf•ft), install drive
belt, accelerate the vehicle at low speed
(maximum 30 km/h (20 MPH)) and apply the
brake; repeat 5 times. Retorque screw to
125to135N•m (92 to 100 lbf•ft).
(12)
At 4000 (600 HO SDI models) or 3500 (800
HO SDI models) RPM with APS discon-
nected.
mmr2004-Rev 407

Table of Contents

Other manuals for Ski-Doo REV Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ski-Doo REV Series and is the answer not in the manual?

Ski-Doo REV Series Specifications

General IconGeneral
ChassisREV
Track Width15 in
Fuel Capacity10.6 gal
Seating Capacity1
ReverseAvailable on most models
Electric StartAvailable on most models

Related product manuals