Ski-Doo REV Series Shop Manual

Section 07 ELECTRICAL SYSTEM
Subsection 05 (TESTING PROCEDURE)
529 035 869
A32E2VA
529 035 675
TYPICAL
When cables are connected a beeping signal from
the reverse buzzer will be heard (if vehicle is so
equipped). This indicates that the MPEM is now
ready to transfer programming operations.
Once MPEM calibration program checking is
done, unplug 9 volt adaptor and supply cable.
Turn on programmer then enter password.
From main menu select no. 3. VEHICLE INFO; ←
Trs.
1. CHECK KEYS
2. PROGRAM KEY
>3. VEHICLE INFO
4
START VEH.
+
A30E1XA
Vehicle information is transferred from MPEM to
programmer.
A30E1YA
TRANSFER
PGMR MPEM
NOTE: In fact the programmer takes a copy of
all vehicle parameters scribed in MPEM. This
copy will be modified within the programmer then
transferred to the MPEM.
Select no. 4. ENGINE PARAMETER.
A30E1ZA
+
>4 ENGINE PARAM.
2. DELIVERY DATE
1. CUSTOMER NAME
3. VEH. SERIAL#
Select no. 3 CALIBRATION.
A30E2IA
2. ENGINE SERIAL#
1. TIMING ADJUST
>3. CALIBRATION
Press ENTER ← Trs.
Following screen appears temporarily:
A30E2BA
VERIFY
PGMR MPEM
VERIFY
PGMR MPEM
Andthenfollowingscreenshowingtheactualcal-
ibration number in the MPEM.
A30E2JA
CALIBRATION NUMBER
XXX XXX XXX
MODIFY?
YES >NO
mmr2004-Rev 273

Ski-Doo REV Series Specifications

General

Chassis	REV
Track Width	15 in
Fuel Capacity	10.6 gal
Seating Capacity	1
Reverse	Available on most models
Electric Start	Available on most models