Snap-On Zeus - Page 142

Scope and Multimeter Operations Ignition Scope
135
Other
Other is used for ignition systems that do not fit any of the other categories (e.g
rotary engine).
NOTE
This selection should not be used to view waveforms. It is only used to supply
an RPM signal.
Select the applicable RPM factor.
Figure 9-63
Traces (Ignition Scope Trace Setup)
Trace Setup (Figure 9-64) allows you to:
– Change the KV scale
– Display or hide the trace
– Invert the trace
– Turn on/off Coupling AC (only selectable if a “time” based sweep is used)
– Move the Zero Base line using the slider (right side)
Setup Notes:
– Trace 2 is only active when in Wasted Spark Mode
– Raster Spacing (Figure 9-65) adjustment is only available in Raster mode.
Figure 9-64