Scanner Basic Operation
45
z Identifying a vehicle:
1. Select Scanner from the Home screen.
A list of vehicle manufacturers (makes) will display (Figure 5-1).
In addition, the last four scanned vehicles are listed at the top of the screen
(Recent Vehicles) for quick-re-identification if needed.
Select the icons to expand/collapse the list.
Figure 5-1 Typical - Manufacturer list
2. Select a manufacturer or vehicle from the list. If a Recent Vehicle is selected,
that vehicle will be re-activated.
A model year menu will display.
You can limit the number of manufacturers that appear on the list by selecting
Configure Favorites from the toolbar. See Configuring the Favorites List on
page 90 for details.
3. Select the vehicle year.
A list of vehicle types or models will display. Several selections may be
required to identify the vehicle type and model, follow the screen prompts and
enter the required information.
A confirmation page showing the identified vehicle will display once all the
required data has been entered. If needed, enter the vehicle VIN, odometer
reading and license plate (Figure 5-2). Review the information to make sure it
is correct.
Figure 5-2
4. Select OK (Figure 5-2).
Camera Scan Vehicle Identification
Depending on the vehicle, the vehicle’s VIN barcode or Data Matrix code may be
scanned to identify the vehicle. The location of these codes will vary, however they
can be commonly found on the drivers side door or door jamb.
1. Select Scanner from the Home screen.
2. From the vehicle selection page, select VIN Entry from the upper toolbar
(Figure 5-3).
To Next Page
Loading...
Need help?
General
