Spacelabs BleaseSirius - Page 14

14
Figures
Figure 1 - BleaseSirius Anesthetic Machine .............................................................22
Figure 2 - Electrical Labeling ......................................................................................27
Figure 3 - PEEP Diagram ...........................................................................................31
Figure 4 - Ventilator Schematic ..................................................................................38
Figure 5 - Absorber Pneumatic Schematic .................................................................39
Figure 6 - Pneumatic Circuit .......................................................................................40
Figure 7 - BleaseSirius Annual Planned Maintenance Kit
PN 14000511 ......................................................................................46
Figure 8 - BleaseSirius Four Year Planned Maintenance Kit PN 14000512 ..............47
Figure 9 - Pipeline Fitting & ‘O’ Ring...........................................................................49
Figure 10 - AGSS .....................................................................................................50
Figure 11 - Pop-off Valve ............................................................................................51
Figure 12 - Bellows Assembly ....................................................................................52
Figure 13 - Pneumatic Module ...................................................................................54
Figure 14 - Primary Regulator ....................................................................................57
Figure 15 - BleaseSirius Checkout Sheet (PN 073-0301-00 Rev. C) .........................64
Figure 16 - Connect the Pipeline Test Shut-off Valve .................................................66
Figure 17 - N
2
O Pipeline Gauge .................................................................................67
Figure 18 - Connect Pressure
Measuring Device ...............................................................................69
Figure 19 - Regulator Nut and Set Crew Locations ....................................................69
Figure 20 - Test Hose Assembly .................................................................................71
Figure 21 - Test Hose Connections ............................................................................72
Figure 22 - Connect O
2
Analyzer (L) and Tubing to AGSS (R) ...................................73
Figure 23 - Pressure Build-up Test .............................................................................74
Figure 24 - Fit 6 mm Plug ...........................................................................................75
Figure 25 - Steps 5 and 8 ...........................................................................................75
Figure 26 - Step 4: Plug the CGO Taper ....................................................................76
Figure 27 - Steps 6 and 8 ...........................................................................................76
Figure 28 - O
2
Flush Test ............................................................................................77
Figure 29 - Connect Pressure Measuring Device.......................................................77
Figure 30 - Suction Gauge and Bowl..........................................................................78
Figure 31 - Expiratory Valve Test Setup .....................................................................79
Figure 32 - Setup for Inspiratory Valve Test ...............................................................80
Figure 33 - Steps 3 & 4 of the Inspiratory Valve Test .................................................81
Figure 34 - Connect a Pressure Measuring Device....................................................81
Figure 35 - Connect the Pressure Sampling Tee .......................................................82
Figure 36 - Step 5: Occlude the Bag Port...................................................................82
Figure 37 - Exhaust Port Location ..............................................................................83
Figure 38 - Step 11: Disconnect Patient Hose ............................................................84