Spacelabs BleaseSirius - Suction Controller Removal;Replacement; Figure 131 - Suction Controller Removal; Replacement

169
5.18 Suction Controller Removal/Replacement
1. Remove rear panel (see section 5.1).
2. Remove the two M5
screws (A&B) and
the M4 screw (C).
The controller and its
bracket can be pulled
back clear of the front
molding. Disconnect the
pipe connections.
A
C
B
Figure 131 - Suction Controller Removal / Replacement
3. Remove the suction
controller from its
bracket by removing the
two ‘pozi-drive’ screws
(D).
D
D
Detailed Repair Procedures