Spacelabs BleaseSirius - Page 16

16
Figures
Figure 77 - Assemble the Spring, Spring Rest and Bonnet ......................................126
Figure 78 - Slip Ring Location ..................................................................................126
Figure 79 - Diaphragm Assembly .............................................................................126
Figure 80 - Fit the Actuator Assembly ......................................................................127
Figure 81 - Attach the Bonnet to the Regulator ........................................................127
Figure 82 - Fit the Relief Valve to the Regulator ......................................................128
Figure 83 - Location of Valve Retaining Screws .......................................................129
Figure 84- Backbar Valve .........................................................................................129
Figure 85 - CGO Block (up to Feb 2009)..................................................................130
Figure 86 - Alarm Block Removal (up to Feb 2009) .................................................131
Figure 87 - Alarm Block Removal (Feb 2009 onwards) ............................................132
Figure 88 - CGO Adjustment (up to Feb 2009) ........................................................133
Figure 89 - Valve Adjuster and Disc Removed (up to Feb 2009) .............................134
Figure 90 - CGO Block (Feb 2009 onwards) ............................................................135
Figure 91 - Location of (4) Suction Plate Screws .....................................................136
Figure 92 - Location of (3) ACGO Assembly Screws ...............................................136
Figure 93 - Location of 6 mm Tubing ........................................................................136
Figure 94 - Location of 8 mm Tubing ........................................................................137
Figure 95 - Location of 6 mm Tubing ........................................................................137
Figure 96 - Location of 8 mm Stem ..........................................................................137
Figure 97 - Location of Microswitch ..........................................................................138
Figure 98 - ACGO Tubing Orientation ......................................................................138
Figure 99 - ACGO Switch Set to Absorber ...............................................................139
Figure 100 - A.C.G.O Ventilator Screen Display ......................................................139
Figure 101 - Microswitch Components .....................................................................140
Figure 102 - Ventilator Wire Orientation ...................................................................141
Figure 103 - NC Valves (PN 214-1089-00) ..............................................................142
Figure 104 - 4-6 mm Increaser (PN 54200184) and
6-5 mm Reducer (PN 54200110) ......................................................142
Figure 105 - 5 mm Tubing (1) and 6 mm Tubing (2) .................................................143
Figure 106 - Tubing Diagram ....................................................................................144
Figure 107 - Tighten Two Screws .............................................................................145
Figure 108 - Absorber Interface Manifold Assembly .................................................150
Figure 109 - ‘P’ Clip ..................................................................................................151
Figure 110- Absorber Prongs....................................................................................152
Figure 111 - Micro Switch .........................................................................................152
Figure 112 - Setting Ball Catch .................................................................................153
Figure 113 - Lock Screw Insertion ............................................................................154
Figure 114 - Absorber Molding 01 ............................................................................155
Figure 115 - Absorber Molding 02 ............................................................................155