Window watchdog (WWDG) RM0008
493/1128 DocID13902 Rev 15
case, the corresponding interrupt service routine (ISR) should reload the WWDG counter to
avoid the WWDG reset, then trigger the required actions.
The EWI interrupt is cleared by writing '0' to the EWIF bit in the WWDG_SR register.
Note: When the EWI interrupt cannot be served, e.g. due to a system lock in a higher priority task,
the WWDG reset will eventually be generated.
20.4 How to program the watchdog timeout
You can use the formula in Figure 184 to calculate the WWDG timeout.
Warning: When writing to the WWDG_CR register, always write 1 in the
T6 bit to avoid generating an immediate reset.
Figure 184. Window watchdog timing diagram
The formula to calculate the timeout value is given by:
where:
t
WWDG
: WWDG timeout
t
PCLK1
: APB1 clock period measured in ms
Refer to the table below for the minimum and maximum values of the T
WWDG.
AIB
7;=
4;=#.4DOWNCOUNTER
2EFRESHNOTALLOWED
X&
2EFRESHALLOWED
4IME
4BIT
2%3%4
t
WWDG
t
PCLK1
4096× 2
WDGTB
×
t 5:0[]1+()×= ms()
To Next Page
Loading...
Need help?
General
