1A-57 Engine General Information and Diagnosis:
P0110-L (Use of SDS)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-7)”.
3) Check the IAT sensor coupler (1) for loose or poor
contacts.
If OK, then check the IAT sensor lead wire continuity.
4) Disconnect the IAT sensor coupler and ECM coupler.
Refer to “ECM Removal and Installation in Section 1C
(Page 1C-1)”.
5) Check there is no continuity between the Dg wire “A”
and ground, B/Br wire “B” and ground, Dg wire “A” and
B/Br wire “B”.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Is there no continuity?
Go to Step 2. Short circuit in the Dg or
B/Br wire.
1
I944H1110042-01
(A)
“A”
“B”
I944H1110132-01
(A)
“A”
“B”
I944H1110133-01
To Next Page
Loading...
