Suzuki SFV650 - Oil Pipe Inspection; Specifications; Service Data; Tightening Torque Specifications

Engine Lubrication System: 1E-14
• Tighten the oil pipe stopper screw (2) to the specified
torque.
NOTE
Align the projection “A” of the oil pipe with
the groove “B” of its stopper.
Tightening torque
Oil pipe stopper screw (a): 8 N·m (0.8 kgf-m, 6.0
lbf-ft)
• Reinstall the clutch. Refer to “Clutch Installation in
Section 5C (Page 5C-9)”.
Oil Pipe Inspection
B944H11506015
Inspect the oil pipe the following procedures:
1) Remove the oil pipe. Refer to “Oil Pipe Removal and
Installation (Page 1E-13)”.
2) Inspect the oil pipe for clogging. Clean the oil pipe if
necessary.
3) Install the oil pipe. Refer to “Oil Pipe Removal and
Installation (Page 1E-13)”.
Specifications
Service Data
B944H11507001
Oil Pump
Oil
Tightening Torque Specifications
B944H11507002
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
(a)
2
“A”
“B”
I944H1150040-01
I944H1150041-01
Item Standard Limit
Oil pressure (at 60 °C, 140 °F)
200 – 600 kPa (2.0 – 6.0 kgf/cm
2
, 28 – 85 psi)
at 3 000 r/min
—
Item Specification Note
Engine oil type SAE 10W-40, API SF/SG or SH/SJ with JASO MA
Engine oil capacity
Change 2 400 ml (2.5/2.1 US/lmp qt)
Filter change 2 750 ml (2.9/2.4 US/lmp qt)
Overhaul 3 000 ml (3.2/2.6 US/lmp qt)
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Main Oil gallery plug (M12) 21 2.1 15.0 )(Page 1E-6)
Oil pressure regulator 27 2.7 19.5 )(Page 1E-7)
Oil cooler union bolt 70 7.0 50.5 )(Page 1E-8)
Oil pressure switch 14 1.4 10.0 )(Page 1E-9)
Oil pressure switch lead wire bolt 1.5 0.15 1.0 )(Page 1E-9)
Piston cooling oil jet bolt 10 1.0 7.0 )(Page 1E-10)
Oil gallery plug (M8) 18 1.8 13.0 )(Page 1E-11)
Oil gallery plug (M6) 10 1.0 7.0 )(Page 1E-11)
Oil pipe stopper screw 8 0.8 6.0 )(Page 1E-14)