9B-14 Lighting Systems:
4) After finishing the hazard switch inspection, reinstall
the removed parts.
Turn Signal Switch Inspection
B944H19206021
Inspect the turn signal switch in the following
procedures:
1) Remove the left frame body cover. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-4)”.
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the turn signal switch for continuity with a
tester. If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebars Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the turn signal switch inspection,
reinstall the removed parts.
Passing Light Switch Inspection
B944H19206022
Inspect the passing light switch in the following
procedures:
1) Remove the left frame body cover. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-4)”.
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the passing light switch for continuity with a
tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebars Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the passing light switch inspection,
reinstall the removed parts.
1
I944H1920036-03
L
PUSH
R
Lg Lbl B
Color
Position
I944H1920039-01
1
I944H1920036-03
PUSH
Position
Color
O Y
I944H1920041-01
To Next Page
Loading...
