Suzuki SFV650 - Engine Sprocket Removal and Installation

3A-2 Drive Chain / Drive Train / Drive Shaft:
Engine Sprocket Removal and Installation
B944H13106002
Removal
1) Remove the gearshift link arm (1) by removing its
bolt (2).
NOTE
Mark the marking to the matching surface of
gearshift link arm before removing.
2) Remove the engine sprocket outer cover (3) by
removing its screws (4).
3) Remove the speed sensor (5).
4) Remove the engine sprocket inner cover (6) by
removing its bolts (7).
5) Remove the dowel pins (8).
6) Remove the speed sensor rotor (9) by removing its
bolt (10) while depressing the rear brake pedal.
7) Flatten the lock washer (11).
8) Remove the engine sprocket nut (12) while
depressing the rear brake pedal.
9) Remove the lock washer (11).
10) Loosen the rear axle nut (13).
11) Support the motorcycle with a jack or wooden block.
CAUTION
!
Make sure that the motorcycle is supported
securely.
12) Loosen the chain adjuster bolts (14) to provide
additional chain slack, left and right.
1
2
I944H1310001-03
3
4
I944H1310002-03
5
6
7
I944H1310003-03
8
9
10
I944H1310004-05
11
12
I944H1310030-02
14
14
13
I944H1310005-02