Suzuki SFV650 - Primary Drive Gear Removal and Installation

Clutch: 5C-14
Push Rod (Right)
Inspect the push rod for bend and damage.
If any defects are found, replace the push rod with a new
one.
Clutch Sleeve Hub and Primary Driven Gear
Assembly
Inspect the slot of the clutch sleeve hub and primary
driven gear assembly for damage or wear caused by the
clutch plates. If necessary, replace it with a new one.
Inspect the primary driven gear bushing for any damage.
Inspect the spring of primary driven gear for any
damages. If necessary, replace it with a new one.
Primary Drive Gear Removal and Installation
B944H15306021
Removal
1) Remove the clutch cover. Refer to “Clutch Removal
(Page 5C-7)”.
2) Hold the clutch pressure plate with the special tool
and loosen the primary drive gear bolt.
Special tool
(A): 09930–40113 (Rotor holder)
CAUTION
!
This bolt has left-hand Thread.
3) Remove the clutch components (1).
Refer to “Clutch Removal (Page 5C-7)”.
4) Remove the primary drive gear bolt (2), water pump
drive gear (3) and primary drive gear assembly (4).
I944H1530050-01
I944H1530051-01
I944H1530052-01
(A)
I944H1530053-01
1
I944H1530055-01
4
2
3
I944H1530056-03