Suzuki SFV650 - Engine Assembly Installation

Engine Mechanical: 1D-22
42) Remove the front left engine mounting bolt (50).
43) Remove the front right engine mounting bolt (51) and
spacer (52).
44) Remove the engine mounting bolts and gradually
lower the engine. Then, take off the drive chain from
the driveshaft.
45) Remove the engine assembly (53).
CAUTION
!
Be careful not to contact the rear exhaust
pipe with the frame (54) and swingarm.
Engine Assembly Installation
B944H11406061
Reinstall the engine in the reverse order of engine
removal. Pay attention to the following points:
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
• Gradually raise the engine assembly, and then put the
drive chain (1) on the driveshaft (2).
CAUTION
!
Be careful not to catch the wiring harness
between the frame and the engine.
• Install the three mounting bolts (3), (4) and (5) from
left side, and tighten their nuts.
NOTE
The engine mounting nuts are self-locking.
Once the nuts have been removed, they are
no longer of any use.
50
51
52
I944H1140315-03
54
53
I944H1140316-02
1
2
I944H1140317-02
3
I944H1140318-02
4
5
I944H1140319-02